Before you begin the setup procedure, double-check the following:You’re connected to the internet through Wi-Fi.You’re familiar with your current Wi-Fi settings (Wi-Fi name and password / security key). Click here for information on how to look for them. The light on the Linksys RE6400 is glowing orange and it is hooked into a power source.
To set up the Linksys extender, hit the WPS button on the router and then on the Linksys RE6400 setup, making sure both devices are close to one another. When you push the WPS button, the extender’s light will begin to flash, and after a successful configuration, it will turn solid green. After setup, the extender may be disconnected and installed in its chosen position; if the extender light is green, the location is okay; otherwise, move the extender closer to the router.
Is it possible to use an Ethernet wire to connect a WiFi extender?
Yes, you may use an Ethernet wire to connect a Wi-Fi Extender for two purposes. If you are using or considering utilising a Wi-Fi extender, check to see if it is compatible with an ethernet wire.Use the web-based setup procedure if your router does not support WPS. Connect the extender to the PC, either wirelessly or cable, and open a browser to the IP 192.168.1.1. It will take you to the extender setup page, where you must complete the setup by following the on-screen instructions. Once configured, the extension will display a solid green light.
Use the web-based setup procedure if your router does not support WPS. Connect the extender to the PC, either wirelessly or cable, and open a browser to the IP 192.168.1.1. It will take you to the extender setup page, where you must complete the setup by following the on-screen instructions. Once configured, the extension will display a solid green light.
What is the procedure for connecting my Linksys WiFi extender to a new router?
Configuring a Linksys Wireless-N Range Extender manually then follow the steps shown below:
- To begin, switch on your RE6400 WiFi extender.
- Turn on your computer and connect it to a WiFi network.
- You’ll be prompted to enter your WiFi password.
- On your computer, open a web browser such as Firefox, Chrome, or Edge.
- In the address box, type extender.linksys.com and click enter.
- The login page for the wireless extender will now appear.
- Input the user ID and password for logging in.
- After that, go to the bottom of the page and click the login button
- Go over the Linksys RE6400 setup instructions on the screen now.
And there you have it! It’s time to set up your RE6400 AC1200 Boost EX WiFi Range.Extender. If these procedures don’t work for you, go to our Linksys Extender Setup page for the entire manual and WPS method instructions. However, if you don’t have a lot of time to go over the Linksys RE6400 Setup procedures again and again, call our specialists right away and we’ll get your extender up and running in no time.
Troubleshooting Steps
- You are unable to connect your extender.
- Make sure your router and extension are in the right place.
- If this is your first time setting up the extender
- you may need to move it closer to the router.
- You may unhook your extender and relocate it to its ultimate place once you’ve set it up.
- Try moving the router and extension to a different location to reduce signal interference. Avoid positioning the router and extender near metal items, stone walls, and reflecting surfaces such as glass or mirrors, as well as other devices that might create signal interference.
- Wait until the Wi-Fi Protected Setup indicator stops flashing before attempting to connect again if you’re using Wi-Fi Protected Setup.
